PDFsharp & MigraDoc Foundation

Hi,

I am using Migradoc to create a print preview of my reports. My data looks like

Section Header 1
Data 1
Data 2
Data 3
Section Header 2
Data 1
Data 2
Data 3

Question 1: If majority of my section data does not fit on the current page (however it is possible for a section to be split over 2 pages), I would like the whole section to be moved to the next page. For this I need to find out how many lines remain on a page that can be used to display data. Is there a way to do this?

Question 2: If I use a table to display this data, it is possible that a few entries in a section may appear on the next page. Is there a way to figure when this happens so for the data on the next page I can display the section header again?

Thanks
AK

Hi!

Re question 2:
The header rows of a table will be repeated on every new page.
So if you start a new table with every section, this will do the trick.

Re question 1:
I cannot see a simple solution.

_________________
Regards
Thomas Hoevel
PDFsharp Team