PDFsharp & MigraDoc Foundation
http://forum.pdfsharp.de/

Is there any way to print the PDF content vertically
http://forum.pdfsharp.de/viewtopic.php?f=2&t=4261
Page 1 of 1

Author:  chandan [ Thu Jun 17, 2021 8:32 pm ]
Post subject:  Is there any way to print the PDF content vertically

Hi,

We are using PDF sharp in our application to render tables on PDF. But with new requirement from the customer, we need to have dynamic columns in the table and that can grow upto 30 columns. Is there any way to print the content vertically at least so that the table doesn't cut off on the right (if the settings have been set to vertical as page orientation) and no data is lost? And may be allow scrollbar someway for the table if printed vertically. Please advise.

Thanks,
Chandan

Author:  TH-Soft [ Fri Jun 18, 2021 7:08 am ]
Post subject:  Re: Is there any way to print the PDF content vertically

Hi!

Are you asking about PDFsharp or about MigraDoc?

With PDFsharp you have full control about anything. You can increase the page width when adding more columns, you can increase the page height when adding more rows. When viewing in Adobe Reader there will be scrollbars where they are needed.
All you have to do is use dynamic page sizes.

Author:  chandan [ Fri Jun 18, 2021 2:12 pm ]
Post subject:  Re: Is there any way to print the PDF content vertically

Awesome. It worked per expectations on setting the page width. BTW, it was about PDFSharp. Thanks a lot :D

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/